Smoke system for 3m FC1 3D Jet
product description
Smoke system for 3m FC1 3D Jet
Installation:
The smoke pump comes with just two wires:
- Futaba connector for signal – Connect to your receiver or powerbox to the output that you will be using to control the on/off position as well as the flow.
- XT60 connector for power – Connect a 2S lipo to the power input (voltage input 6.8v-13.0v)
We do not recommend joining both sets of positive and negative wires in order to pull power directly from the receiver or powerbox! - Connect the pump nipples to the smoke tank and exhaust tubes, taking especial notice of the direction of flow, indicated on the pump with an engraved arrow.
Setup:
All setup is done via the radio, using a single channel:
- -100% to -30% radio signal, the pump is ON with an intermittent smoke flow. The higher the % the more fuel flow.
- -30% to +30% radio signal (channel center) the pump is OFF
- +30% to +100% radio signal, the pump is ON with a continuous smoke flow. The higher the % the more fuel flow
You can also use the LED on the smoke pump to read out its current situation:
- Solid red: Power is on, voltage is incorrect (below 6.8v or above 13.0v)
- Flashing red: Overcurrent, please check that the pump is not blocked or jammed
- Fixed blue: Lost radio signal
- Flashing blue: Pump running, in intermittent flow mode
- Fixed green: Power is on, voltage is correct (between 6.8v and 13.0v)
- Flashing green: Pump running, in continuous flow mode
Downloads
file | file size |
---|---|
produktsicheheitshinweis_Zubehoer.pdf (2.63 MB) | 2.63 MB |
product_saftey_information_accessories.pdf (2.63 MB) | 2.63 MB |
Manufacturer identification
Manufacturer identification
Name: Pilot-RC Co, Ltd.E-Mail adress: jeane@pilot-rc.com
Address addition: No.1, Liye Road, South District
ZIP Code: 528455
City: Zhongshan city, Guangdong Province
EU economic operator
Name: FINAL AeroTec GmbHE-Mail adress: info[at]final-aerotec.de
Streetaddress: Hoffmannallee 55
ZIP Code: 47533
City: Kleve
Phone: +49 (0) 2821 / 8917175